| |
 |
>> Download Product Catalogue |
Anabond Tuffseald Polysulphide |
Two part Polysulphide sealant |
 |
| Anabond Tuffseal Polysulphide sealant is a uversally usable for concrete joint sealant and industrial insulation galzing sealant. This is two part system. After mixing Resin and Hardener, the polymerization is initiated at room temperature, which proceed further until it is cured. |
Features |
 |
It has good adhesion properties. |
|
It is mainly used as a fuel resistant sealant. |
|
Typical Use |
|
Concrete joint sealant in airport |
|
Industrial Glazing sealant |
|
Construction sealant |
|
Application - By Manual |
|
Hardener is to mix Resin and stir gently to get uniform colour mix. |
|
| |
Product Description (Average values) |
Anabond TUFFSEALD Polysulphide (Part A - Resin) |
| Colour |
Off-White |
| Viscosity @30°C, cPs |
7200000 ± 300000 |
| Specific Gravity @30°C |
1.61 ± 0.02 |
| Shelf life, unopened |
9 months |
| Disposal |
Disposal procedures approved by national local authorities |
|
|
Anabond TUFFSEALD Polysulphide ( Part A - Resin) |
| Colour |
Brown |
| Viscosity @30°C, cPs |
1.50 ± 0.02 |
| Shelf life, unopened |
9 months |
| Disposal |
Disposal procedures approved by national local authorities |
|
|
| |
Storage Condition |
| This resin and hardener should be stored at a temperature not exceeding 40°C in original sealed containers. At higher storage temperature the storage life would decrease sharply. The resin and hardener containers should not be exposed to sunlight to avoid premature gelation. |
| |
Packaging |
Resin (Part A) |
| 920 gms of material into the 1 litre wide mouth tin container |
Hardener (Part B) |
| 80 gms of material into 100 ml tin container |
| |
|
| |
